I am using level shifters in 2.5V controller and 3.3V IO application. i am using the part SN74CB3T16210.
could some one clarify me if each A port or pin can be in any direction or all the A ports are to be on single direction?
For SN74CB3T16210, yes, Each A port or pin can be in any dirction if the OE is enable. any further concern, please let me know.
Sorry for jumping into the thread, but I think this is the correct place to chip-in.
I am also using the same IC (SN74CB3T16210) for my application. In my case the voltage is not translated from 2.5 to 3.3 volts. Is it that, it only works for translating voltage from HIGH to LOW?
Thanks in Advance.
The datasheet actually say " if the input applied is in range VCC-1V to 5.5V, the output voltage will approximate to VCC". So just look into the voltage level you are applying as input and also the VCC voltage you are using. can i know what is the vcc you are applying in your case?
All content and materials on this site are provided "as is". TI and its respective suppliers and providers of content make no representations about the suitability of these materials for any purpose and disclaim all warranties and conditions with regard to these materials, including but not limited to all implied warranties and conditions of merchantability, fitness for a particular purpose, title and non-infringement of any third party intellectual property right. TI and its respective suppliers and providers of content make no representations about the suitability of these materials for any purpose and disclaim all warranties and conditions with respect to these materials. No license, either express or implied, by estoppel or otherwise, is granted by TI. Use of the information on this site may require a license from a third party, or a license from TI.
TI is a global semiconductor design and manufacturing company. Innovate with 100,000+ analog ICs andembedded processors, along with software, tools and the industry’s largest sales/support staff.