• State
  • Locked Locked
  • Replies 1 reply
  • Subscribers 18 subscribers
  • Views 269 views
  • Users 0 members are here
Support feedback
Options
Options
Similar topics

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

TXS0102: concern about our schematic

Takao Yamamoto
Genius 4135 points
Other Parts Discussed in Thread: TXS0102

Dear all,

We use TXS0102 under our condition.*see attachment file

Are there some concern about this?

Are there something to pay attention?

We cannot change schematic on the traditional board,

so we must use two TXS0102 to communicate with module on the additional board.

Best regards,Our schematic.pdf

  • 0
    TI__Genius 17205 points

    Dear Takao-san,

    In order to better serve you I would like to get some more information about your design.  Can you elaborate on the "Load"?  What is it?  Are there three loads or is that representative of more than three?  What is the total capacitive load on the bus?  Do you have pull up resistors on the bus?  What data rate are you hoping to achieve?

    Sincerely,

    -Francis Houde