This thread has been locked.
If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.
Part Number: TPS2553
we've used the TPS2553DRV in at least two designs that I've tested now. Applying 5.5V to the output pin while the device is enabled doesn't cause the device to turn off or pull the FAULT# pin low. Instead I can happily feed the overvoltage back up through our power tree.
I'm testing this in circuit by using a jumper wire from EN to 3V3 and then applying a voltage of 5V5+ on the output.
We are glad that we were able to resolve this issue, and will now proceed to close this thread.
If you have further questions related to this thread, you may click "Ask a related question" below. The newly created question will be automatically linked to this question.
In reply to Michael Tan:
yes, I fully understand the conditions for which the reverse voltage protection should be working. Which is why I opened this ticket. The input is 5V and as my ticket suggests, I can apply 5.5V and not have the protection function work. I tried with 6.5V as well just to be sure.
I don't understand your suggestion of adding an extra resistor in parallel with the input cap. Surely the protection circuit should function correctly without extra components not detailed in the data sheet?
In reply to Shareef Jalloq7:
OK, perhaps I'm not understanding the feature. I assumed that the reverse voltage protection was designed to protect any upstream regulators from this fault condition. But you're saying this feature doesn't work under normal operating conditions unless you add a loading resistor to slow the rise time on the input voltage. Shouldn't this information be detailed in the data sheet and the typical application sections be updated?
So is there an official solution to this issue? Would a TVS diode on the input be suitable rather than a resistor?
You also mentioned that this is an old part, is there an equivalent newer version that actually has reverse voltage protection that works?
All content and materials on this site are provided "as is". TI and its respective suppliers and providers of content make no representations about the suitability of these materials for any purpose and disclaim all warranties and conditions with regard to these materials, including but not limited to all implied warranties and conditions of merchantability, fitness for a particular purpose, title and non-infringement of any third party intellectual property right. TI and its respective suppliers and providers of content make no representations about the suitability of these materials for any purpose and disclaim all warranties and conditions with respect to these materials. No license, either express or implied, by estoppel or otherwise, is granted by TI. Use of the information on this site may require a license from a third party, or a license from TI.
TI is a global semiconductor design and manufacturing company. Innovate with 100,000+ analog ICs andembedded processors, along with software, tools and the industry’s largest sales/support staff.