This thread has been locked.
If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.
Part Number: TRS3122E
I have used a pair of the TRS3122E as the evaluation board and choose R6 and R7 with 50 Ohm. During the common noise test - injecting 1000V, 100kHz signal into the GND of the TR3122E and the chassis ground, the communication is disrupted. After change R6 and R7 back to 0 Ohm, the common mode noise immunity is much better. Do you have any application note or suggestion on how to select the proper R6 and R7? Or this is bus specific? Is it possible to give an example on how to select the correct value for R6 and R7? We could not even measure the waveform properly when common mode noise is being injected.
Thank you very much,
We are glad that we were able to resolve this issue, and will now proceed to close this thread.
If you have further questions related to this thread, you may click "Ask a related question" below. The newly created question will be automatically linked to this question.
In reply to frank wong:
It seems like the images still aren't working, and it sounds these are needed in order to understand how R6 and R7 are connected. Can you please try sending them again? It should work if you click the "Insert Code, Attach Files and more..." link below the text input field. Then you can use the "Insert/Edit Media" button on the toolbar above the test field.
If that still doesn't work, is it OK if I contact you via the e-mail address used by your ti.com account?
In reply to Max Robertson:
The R6 and R7 is the serial termination resistor of the Rin 1 and Rin2.
All content and materials on this site are provided "as is". TI and its respective suppliers and providers of content make no representations about the suitability of these materials for any purpose and disclaim all warranties and conditions with regard to these materials, including but not limited to all implied warranties and conditions of merchantability, fitness for a particular purpose, title and non-infringement of any third party intellectual property right. TI and its respective suppliers and providers of content make no representations about the suitability of these materials for any purpose and disclaim all warranties and conditions with respect to these materials. No license, either express or implied, by estoppel or otherwise, is granted by TI. Use of the information on this site may require a license from a third party, or a license from TI.
TI is a global semiconductor design and manufacturing company. Innovate with 100,000+ analog ICs andembedded processors, along with software, tools and the industry’s largest sales/support staff.