TMDS181: Looking for 6.6Gbps retimer

K.Shidara

Expert 3225 points

Part Number: TMDS181

Hi team,

Would you recommend the proper retimer device for

below my customer's requirement.

I am looking for a re-timer to pass 6.6 Gbps to a thin coaxial

cable of about 70 cm long when the next model's examination starts.

Thanks

Best regards,

Shidara

over 5 years ago

0 David (ASIC) Liu over 5 years ago

TI__Guru*** 140015 points

Shidara

Max data rate for TMDS181 is 6G. What protocol are they using that requires 6.6G data rate? Do they also have a system block diagram and insertion loss profile?

Thanks
David

0 K.Shidara over 5 years ago in reply to David (ASIC) Liu

TI__Expert 3225 points

Hi David,

Our customer will use Xilinx Aurora protocol.

Regarding to insertion losses, I'd like to discuss by private message because of customer's specific informartion.

Would you provide email address or may I send email directly to you?

Thanks

Best regards,

Shidara

0 David (ASIC) Liu over 5 years ago in reply to K.Shidara

TI__Guru*** 140015 points

Shidara-san

I sent you my contact info, please check.

Thanks
David

Interface

Interface forum

TMDS181: Looking for 6.6Gbps retimer