DP83849C: RJ45 Loopback

Rochus

Prodigy 150 points

Part Number: DP83849C

Dear DP83894c Experts,

I would like to run a RJ-45 loopback test; that is with a plug on the RJ45 that loops the TX data to RX.

Post reset, are there any registers that I must configure in order to see a successful loopback of an ethernet frame?

Kind regards,

Rocco

over 4 years ago

0 Geet Modi over 4 years ago

TI__Mastermind 26320 points

With Auto-Neg set to 100M, you shall see the link is up and data transfer shall go thru.

Regards,
Geet

0 Geet Modi over 4 years ago in reply to Geet Modi

TI__Mastermind 26320 points

Hi,

I am closing this thread. Incase you need further assistance, kindly open new thread and provide reference to this thread.

Regards,

Geet

0 Rochus over 4 years ago in reply to Geet Modi

Prodigy 150 points

Hi Geet,

I proceeded with the RJ-45 loopback before answer arrived and it worked. It works without auto-negotiation. It works with 100 bits/sec set. I guess this is not abnormal , yes ?

Kind regards,

Rocco

0 Geet Modi over 4 years ago in reply to Rochus

TI__Mastermind 26320 points

Tx and Rx are seperate and you can setup link using external loop back.

Regards,
Geet

Interface

Interface forum

DP83849C: RJ45 Loopback