[ DS90UB928 ] Output Amplitude Control

Kenichiro

Mastermind 9165 points

[ DS90UB928 ] Output Amplitude Control

Hi Expert,

Is there any of ways to change the output amplitude from TxOUTn+/- and TxCLKOUT-/+?

I can't find out setting pin and/or registers, however it's appreciated if you have ideas.

Thanks,

Ken

over 9 years ago

0 Kenichiro over 9 years ago

Mastermind 9165 points

Issue closed.
If you have same issue, please contact to me or your local TI representatives.

Thanks,
Ken

0 Daniele Loperfido over 8 years ago in reply to Kenichiro

Prodigy 60 points

Please,
I have the same issue. Can you please tell me how you fixed the issue ?

Best Regards,
Daniele

0 Kenichiro over 8 years ago in reply to Daniele Loperfido

Mastermind 9165 points

Hi Daniele,

The current datasheet (Rev.B) has erratum.
I'm not sure whether I can share the details with you, so suggest you to contact to your local TI representatives.

Thanks,
Ken

Interface

Interface forum

[ DS90UB928 ] Output Amplitude Control

[ DS90UB928 ] Output Amplitude Control