• State
  • Locked Locked
  • Replies 1 reply
  • Subscribers 32 subscribers
  • Views 275 views
  • Users 0 members are here
Support feedback
Options
Options
Similar topics

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

DS110DF410: DS110DF410:

LIOR GRINBERG
Prodigy 10 points
Part Number: DS110DF410

Hi,

The datasheet of the device notes that for master mode programming , the EEPROM must support fSDC greater than 400khz (page 7 note 5). but at the electronic characteristic table it is noted that the typical rate is 400khz.

my question: can i use for master mode programming, 400khz EEPROM?

thanks,

Lior

  • 0
    TI__Mastermind 43795 points

    Hi Lior,

    A 1 MHz EEPROM is preferred.

    The 400 KHz specification is based on our device receiving the SMBus clock as a slave device.

    As a Master device, our internal oscillator can run slightly above 400 KHz - so we recommend the 1 MHz EEPROM devices.

    Note: The 400 KHz EEPROM will most likely work fine - I have never heard of one failing due to our clock frequency.

    Regards,

    Lee