Can I use GPIO Pins as TX/RX in CC1350/CC1350 LaunchPad ?

Siva Sankar

Prodigy 80 points

Other Parts Discussed in Thread: CC1350

I am using CC1350 LaunchPad, I need 3 UART for my project, Can I able to convert GPIO Pins to UART ?

over 6 years ago

0 TA12012 over 6 years ago

TI__Mastermind 36375 points

Siva,

No, the CC1350 only has one hardware UART in silicon. It is however possible for you to use the Sensor controller as a software based UART (up to 9600 bits/s). But there is no way to have 3 UARTS on this device.

/TA

0 Selvaprabakaran K over 6 years ago in reply to TA12012

Expert 1210 points

its possible to semaphore TI RTOS Function will be act Multi UART Function

Interface

Interface forum

Can I use GPIO Pins as TX/RX in CC1350/CC1350 LaunchPad ?