Part Number: GD75232
I would like to know the layout trace length from GD75232PWR to connector. What is the maximum value of length?
If I put it near to connector about 3 inches, is it fine with that?
And how about the trace length from Super IO to GD75232PWR?
Are you referring to the trace length from the communication IO's to a DB9S connector like in the image below?
And could you share a schematic because I am not quite sure what you mean by Super IO to GD75232?
In reply to Daniel R Noel:
All content and materials on this site are provided "as is". TI and its respective suppliers and providers of content make no representations about the suitability of these materials for any purpose and disclaim all warranties and conditions with regard to these materials, including but not limited to all implied warranties and conditions of merchantability, fitness for a particular purpose, title and non-infringement of any third party intellectual property right. TI and its respective suppliers and providers of content make no representations about the suitability of these materials for any purpose and disclaim all warranties and conditions with respect to these materials. No license, either express or implied, by estoppel or otherwise, is granted by TI. Use of the information on this site may require a license from a third party, or a license from TI.
TI is a global semiconductor design and manufacturing company. Innovate with 100,000+ analog ICs andembedded processors, along with software, tools and the industry’s largest sales/support staff.