LSF0102: Datasheet Figure 10 Test Conditions

Ting Ye

Genius 11800 points

Part Number: LSF0102

Hello Team,

May I know LSF0102 datasheet Figure 10 Test Conditions of pull up resistors used at A side and B side?

Thank you.

Regards,

Ting

over 5 years ago

0 Dylan Hubbard over 5 years ago

TI__Mastermind 42600 points

Hi Ting,

The pull-ups will be determined by the application and devices interfacing with the LSF0102. Section 9.2.1.2.2 "Pull-up Resistor Sizing" should be used to choose the resistor values. Is there a particular reason you would like to know those test conditions?

0 Ting Ye over 5 years ago in reply to Dylan Hubbard

TI__Genius 11800 points

0 Dylan Hubbard over 5 years ago in reply to Ting Ye

TI__Mastermind 42600 points

Ting,

The waveform is based off the set-up. However, if you look close the translation isn't the same voltage. Again, you should use Section 9.2.1.2.2 "Pull-up Resistor Sizing".

Logic

Logic forum

LSF0102: Datasheet Figure 10 Test Conditions