This thread has been locked.
If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.
Part Number: ISO7841
I have a little doubt about isolators and SPI lines. I need to communicate with four different ADS1299 sharing the same SPI line and with a baud rate of 15.6 MHz. I saw different texas isolators and the parameters are confusing me. I´m using 3V3 on both sides.
Signaling Rate => Up to 150 Mbps
Propagation delay => 16 ns (MAX), 10.8 ns (typical)
Pulse width distortion => 4.2 ns (MAX), typical 0.7 ns
Part-to-part skew => 4.5 ns (MAX)
Output rise/fall time => 0.8 ns (typical)
Signaling Rate => Up to 100 Mbps
Propagation delay => 32 ns (MAX)
Pulse width distortion => 2 ns (MAX), typical 1 ns
Part-to-part skew => 5 ns (MAX), typical 0 ns
Output rise/fall time => 2 ns (typical)
Both fulfill my requirements of isolation. I´d like to know which parameters I need to see in order to have that baud rate for the SPI. Signaling rate of the 7841 is lower than the other, but I think its parameters are better.
ISO7841 belongs to one of our latest digital isolator families. It is designed to be a part far superior to the ISO7241. From SPI communication point of view, the data rate/rise fall times should be parameters of interest. As you mentioned, both the parts are capable of meeting said requirements for SPI @ 15.6MHz.
I would recommend that the ISO7841 be considered for your application.
We are glad that we were able to resolve this issue, and will now proceed to close this thread.
If you have further questions related to this thread, you may click "Ask a related question" below. The newly created question will be automatically linked to this question.
In reply to Anand Reghunathan:
I have same question about ISOW7841 3.3V interface.
i designed it with 5v power supply of ISOW7841 then use 3.3V interface voltage level of DSP(example tms320f28335).
ISO7841W The part , i thinks the 3.3v signal is interfaceable. do you have any other advice for circuit?
In reply to CHOI SEUNG WON:
All content and materials on this site are provided "as is". TI and its respective suppliers and providers of content make no representations about the suitability of these materials for any purpose and disclaim all warranties and conditions with regard to these materials, including but not limited to all implied warranties and conditions of merchantability, fitness for a particular purpose, title and non-infringement of any third party intellectual property right. TI and its respective suppliers and providers of content make no representations about the suitability of these materials for any purpose and disclaim all warranties and conditions with respect to these materials. No license, either express or implied, by estoppel or otherwise, is granted by TI. Use of the information on this site may require a license from a third party, or a license from TI.
TI is a global semiconductor design and manufacturing company. Innovate with 100,000+ analog ICs andembedded processors, along with software, tools and the industry’s largest sales/support staff.