TI E2E Community
A variable 8 bit Binary up down output
I am trying to use a 74ACT11867 or equivalent serial 8 bit up/down BCD counter , to get a variable BCD output . My clock input would vary from 1Hz thru 1kHz. I think I know how control the up & down, it's just the 0-255 BCD output.
LL clears counter HL will load the data on A through H into the counter and it will begin to count from there up or down, whicher is selected.
Thank You. Do I need to have the data inputs all high to have a Binary output?
The data inputs dont matter except when you load the start number. When S1 is high and S0 is low it will load the data into the counter and that is wher it will start counting. If S1 and S0 are in any other state the data pins are ignored.
All content and materials on this site are provided "as is". TI and its respective suppliers and providers of content make no representations about the suitability of these materials for any purpose and disclaim all warranties and conditions with regard to these materials, including but not limited to all implied warranties and conditions of merchantability, fitness for a particular purpose, title and non-infringement of any third party intellectual property right. TI and its respective suppliers and providers of content make no representations about the suitability of these materials for any purpose and disclaim all warranties and conditions with respect to these materials. No license, either express or implied, by estoppel or otherwise, is granted by TI. Use of the information on this site may require a license from a third party, or a license from TI.
TI is a global semiconductor design and manufacturing company. Innovate with 100,000+ analog ICs andembedded processors, along with software, tools and the industry’s largest sales/support staff.