The CBT logic family can interface a 5V part of a system with a 3.3V part of a system by adding a diode between the external Vcc and the output-enable terminals.
Please reference application report "Flexible Voltage-Level Translation with CBT Family Devices": http://www.ti.com/lit/scda006 .
Is it possible to convert 3.3 V CMOS to 5V CMOS using SN74CB3T3245 and pull up resistors?
In reply to Aleksander Vershinin:
Yes this will work. see appnote page 28. http://focus.ti.com/lit/an/scda008/scda008.pdf
In reply to Chris Cockrill:
Can I connect I2C I/F (with pull-ups to 5V) to the SN74CB3T3245?
In reply to Eli Blank:
You can use SN74CB3T3245 only for 5V-3.3V, 5V,3.3V-2.5V translation. I prefer to use PCA9306 for I2C- it is more flexible.
All content and materials on this site are provided "as is". TI and its respective suppliers and providers of content make no representations about the suitability of these materials for any purpose and disclaim all warranties and conditions with regard to these materials, including but not limited to all implied warranties and conditions of merchantability, fitness for a particular purpose, title and non-infringement of any third party intellectual property right. TI and its respective suppliers and providers of content make no representations about the suitability of these materials for any purpose and disclaim all warranties and conditions with respect to these materials. No license, either express or implied, by estoppel or otherwise, is granted by TI. Use of the information on this site may require a license from a third party, or a license from TI.
TI is a global semiconductor design and manufacturing company. Innovate with 100,000+ analog ICs andembedded processors, along with software, tools and the industry’s largest sales/support staff.