TI E2E Community
SN74CB3T16211 FET Switch
Using FET switch SN74CB3T16211 part 3.3V to 1.8V conversion is possible or not? In Data sheet I/O Support levels mentioned like (0.8V, 1.2V, 1.5V, 1.8V, 2.5V, 3.3V, 5V) but in DC voltage - Translation characteristics diagram the output will follow the Vcc (Recommended operating Vcc is 2.3V to 3.6V).
The input can be any level since it is a switch. However the lowest is can translate down to is 2.3V.
The bullet is a little misleading.
You could use a dual voltage translater SN74AVC24T245
or a voltage clamp type device SN74TVC16222A (one side must be open drain)
All content and materials on this site are provided "as is". TI and its respective suppliers and providers of content make no representations about the suitability of these materials for any purpose and disclaim all warranties and conditions with regard to these materials, including but not limited to all implied warranties and conditions of merchantability, fitness for a particular purpose, title and non-infringement of any third party intellectual property right. TI and its respective suppliers and providers of content make no representations about the suitability of these materials for any purpose and disclaim all warranties and conditions with respect to these materials. No license, either express or implied, by estoppel or otherwise, is granted by TI. Use of the information on this site may require a license from a third party, or a license from TI.
TI is a global semiconductor design and manufacturing company. Innovate with 100,000+ analog ICs andembedded processors, along with software, tools and the industry’s largest sales/support staff.