I have tried to program a cc2431 with a simple main program using CC Debugger and IAR 7.51A, when chip has been programmed I receive these
Warning: Verification error on page #0, bank #0, address range 0x00000 - 0x007FF, address 0x00000, 0x20 (on target) != 0xC0
Problem solved, It was a bad connection to ground (central pin...)
I have the same problem with you. Can you detail your reason? "It was a bad connection to ground (central pin...)" : where's it?
Most probably related to how the chip was soldered to the board. It is imperative that the ground pad under the chip is properly connected to the corresponding pad on the PCB.
All content and materials on this site are provided "as is". TI and its respective suppliers and providers of content make no representations about the suitability of these materials for any purpose and disclaim all warranties and conditions with regard to these materials, including but not limited to all implied warranties and conditions of merchantability, fitness for a particular purpose, title and non-infringement of any third party intellectual property right. TI and its respective suppliers and providers of content make no representations about the suitability of these materials for any purpose and disclaim all warranties and conditions with respect to these materials. No license, either express or implied, by estoppel or otherwise, is granted by TI. Use of the information on this site may require a license from a third party, or a license from TI.
TI is a global semiconductor design and manufacturing company. Innovate with 100,000+ analog ICs andembedded processors, along with software, tools and the industry’s largest sales/support staff.