TI E2E Community
Low Power RF & Wireless Connectivity
Low Power RF Hardware & Tools Forum
CC2520 spur at 2421MHz
Attached is a spectral plot of a spur we got at 2421MHz. The CC2520 was configured to CW mode at 2420MHz
At different channels (2405, 2450 2465) We do not get this spur.
We did not encounter any performance problem with the unit, reception and transmission was as expected.
What is the reason for this spur?
Lior6242.CC2520 strange spectral plot.xlsx
I have not seen this before. To be sure I tested a CC2520EM again today at 2420MHz without seeing the mentioned spur.Then I tested using your ref-level -30dBm and LNA active.Now, a significant spurs was observed at 2421MHz. however, with this reference level the spectrum analyzer input is in saturation due to high the +5dBm signal at 2420MHz. My noise spectrum did not resemble yours but I used a FSIQ and not a FSH.
Suggest measuring using a higher reference level
All content and materials on this site are provided "as is". TI and its respective suppliers and providers of content make no representations about the suitability of these materials for any purpose and disclaim all warranties and conditions with regard to these materials, including but not limited to all implied warranties and conditions of merchantability, fitness for a particular purpose, title and non-infringement of any third party intellectual property right. TI and its respective suppliers and providers of content make no representations about the suitability of these materials for any purpose and disclaim all warranties and conditions with respect to these materials. No license, either express or implied, by estoppel or otherwise, is granted by TI. Use of the information on this site may require a license from a third party, or a license from TI.
TI is a global semiconductor design and manufacturing company. Innovate with 100,000+ analog ICs andembedded processors, along with software, tools and the industry’s largest sales/support staff.