TI E2E Community
Low Power RF & Wireless Connectivity
Low Power RF Proprietary Software & SimpliciTI Forum
comunication problem between AP and ED in demo version1.05
When I changed the ez430-RF2500 Wireless Sensor demo code version from 1.02 to 1.05 (both AP and ED). The AP device cannot get signal from ED. The both LED in ED device keep blink (looks it not find the access point). the sensor monitor only show local temperature resding. But when I change back to older version. every ting is ok. I repeated this change several times. the results are the same. Do I need change some setting in IAR when I make this change?
All content and materials on this site are provided "as is". TI and its respective suppliers and providers of content make no representations about the suitability of these materials for any purpose and disclaim all warranties and conditions with regard to these materials, including but not limited to all implied warranties and conditions of merchantability, fitness for a particular purpose, title and non-infringement of any third party intellectual property right. TI and its respective suppliers and providers of content make no representations about the suitability of these materials for any purpose and disclaim all warranties and conditions with respect to these materials. No license, either express or implied, by estoppel or otherwise, is granted by TI. Use of the information on this site may require a license from a third party, or a license from TI.
TI is a global semiconductor design and manufacturing company. Innovate with 100,000+ analog ICs andembedded processors, along with software, tools and the industry’s largest sales/support staff.