New PurePath Wireless Audio firmware released - FW1.4.0

Everyone, 

As you may or may not have seen the new FW1.4.0 is available for download. 

This new release contains a lot of new features, some of which originated here at the E2E forum, so please keep the feedback coming.
For a detailed list of all new features and changes, please refer to the configurator change log.

Short-list of the features in this release:

• Lower latency (down to 10.6 msec for mono applications). Perfect for Microphones and single channel applications (subwoofers) that requires below 16 msec latency. 
• 2 Mbit mode for selected configuration. ~5dB improvement in sensitivity over standard 5Mbit mode. 2 channels with SLAC only. Perfect for speaker and headphone applications that needs the extended range.
• Extensive frequency planning (static and dynamic). 
• Configurable analog and digital input silence detection (for enhanced power control)
• Protocol master synchronization (for applications exceeding the normal 4 channels / 4 slaves limitation). Example: Full 5.1 wireless home theater system.
• Enhanced support for remote control functionality (mouse, keyboard). Example use-case: Remote control with microphone for speech recognition

As always, the User Guide is updated to reflected these new features and changes and remember that more and useful information also can be found in the configurator help system.

You can download the new configurator here:
http://www.ti.com/tool/purepath-wl-cfg

And the updated User Guide here:
http://www.ti.com/lit/ug/swru250k/swru250k.pdf 

Please let us know if you have issues, feature request or general feedback (good or bad).

Thanks and best regards,
The PurePath Wireless audio team.