TI E2E Community
Low Power RF & Wireless Connectivity
When I test spurious emission of CC3000 on 2.4GHz-3.4GHz, how to set RBW and VBW ? When I set RBW=1MHz, the test result will exceed
the criterion. And what is the standard of RBW on spurious emission?
Look forword to your answer. Thank you.
What is your test setup like? From experience, I have seen that the instruments you are using come with application notes and in some cases even small applications that do the whole job for you by automating the configurations of your test setup. That being said, I am not sure if there are settings specific to the CC3000 module. I know for a fact that most standards on in-band and out-of-band spurious emissions are from IEEE or FCC.
As per the TiWi-SL Module Datasheet, it complies with FCC standard; FCC ID: TFB -TIWISL01, 15.247 (Page 32 of the Datasheet).
Read FCC Standard: 15.247 (You should be able to find this on the internet).
All content and materials on this site are provided "as is". TI and its respective suppliers and providers of content make no representations about the suitability of these materials for any purpose and disclaim all warranties and conditions with regard to these materials, including but not limited to all implied warranties and conditions of merchantability, fitness for a particular purpose, title and non-infringement of any third party intellectual property right. TI and its respective suppliers and providers of content make no representations about the suitability of these materials for any purpose and disclaim all warranties and conditions with respect to these materials. No license, either express or implied, by estoppel or otherwise, is granted by TI. Use of the information on this site may require a license from a third party, or a license from TI.
TI is a global semiconductor design and manufacturing company. Innovate with 100,000+ analog ICs andembedded processors, along with software, tools and the industry’s largest sales/support staff.