TI E2E Community
Low Power RF & Wireless Connectivity
DN015 Permanent Frequency Offset Compensation
Welcome to the Low Power RF & Wireless Connectivity Section of the TI E2E Support Community. Ask questions, share knowledge, explore ideas, and help solve problems with fellow engineers. To post a question, click on the forum tab then "New Post".
Due to component inaccuracy (e.g. crystal drift/tolerance) an RF link might suffer a certain frequency offset between transmitter and receiver, which again could cause degraded sensitivity and link performance/range. The CC11xx/CC25xx counteracts this by using a built-in frequency offset compensation algorithm.
This document explains how to make an additional permanent frequency offset compensation.
All content and materials on this site are provided "as is". TI and its respective suppliers and providers of content make no representations about the suitability of these materials for any purpose and disclaim all warranties and conditions with regard to these materials, including but not limited to all implied warranties and conditions of merchantability, fitness for a particular purpose, title and non-infringement of any third party intellectual property right. TI and its respective suppliers and providers of content make no representations about the suitability of these materials for any purpose and disclaim all warranties and conditions with respect to these materials. No license, either express or implied, by estoppel or otherwise, is granted by TI. Use of the information on this site may require a license from a third party, or a license from TI.
TI is a global semiconductor design and manufacturing company. Innovate with 100,000+ analog ICs andembedded processors, along with software, tools and the industry’s largest sales/support staff.