Hi all,
i have two question about TMS320C28346.
1. Interface to an external ADC
Which pin/signal should i use to connect EOC_N (end of conversion) from an adc?
I would like to use the McBSP Interface to connect with the SPI Slave Interface from ADC.
Moreover, i connected the EXTSOC1A to the CONVRUN (Start Conversion) signal on ADC.
It this possible?
2. HRPWM for DRV8402
Which PWM pins should i use for the DRV8402? The DRV8402 needs two complementary pwm signals.
I connected EPWM1A and EPWM1B for full bridge #1 and EPWM2A and EPWM2B for full bridge #2. Is this right?
Best regards,
Florian