Load Program Error

Githin George

Getting an issue during debugging. The cod is not loading to controller.

error message shows like "Load Program Error: C;\test\RAM\Example_F2802xEPwmUpDpwnAQ.out Could not determine target type of file"

Any solution for this?

Thank you

Githin

over 9 years ago

0 Gautam Iyer over 9 years ago

Guru 192875 points

Hi Githin,

First of all when you "Re-build" your project... does it have any errors?

Regards,
Gautam

0 Githin George over 9 years ago in reply to Gautam Iyer

Intellectual 290 points

Hi Gautam,

I cleaned the project and rebuild, there was no error. But when connected with launch pad 28027 to debug, Loading Error is happening.

0 Gautam Iyer over 9 years ago in reply to Githin George

Guru 192875 points

Githin, try in a new workspace. Seems like workspace corruption.

Regards,
Gautam

0 Githin George over 9 years ago in reply to Gautam Iyer

Intellectual 290 points

Hai Gautam,
Its working in another system.
Thank you

0 Gautam Iyer over 9 years ago in reply to Githin George

Guru 192875 points

That's Great! You can try in the same PC by switching to a new workspace: Use this option

Goodluck & Regards,
Gautam

0 Rustam Kuvandykov over 7 years ago in reply to Gautam Iyer

Prodigy 110 points

Hello, I have the same problem. Switching workspace or changing computer is not working. If I 1.turn off +U. 2. Unplug XDS100 from USB.3. turn on +U. 4. Plug XDS100 to USB - > then I can load programm from PC, but it only one time...

C2000™︎ microcontrollers

C2000 microcontrollers forum

Load Program Error