Linker Error while building application for TMS320F28335 MCU

SUNIL SAWANT

Other Parts Discussed in Thread: TMS320F28335, CONTROLSUITE

Hi All,

I am developing application for TMS320F28335 MCU.

I am getting following build errors during link process:

>>   error: can't allocate .text, size 0000102e (page 0) in RAML1 (avail:
            00001000)
>>   error: errors in input - ./Debug/DSP2833x_ECanApplication.out not built

>> Compilation failure

What is the reason for error ?

Please suggest a solution to solve the problem.

Thank you,

Sunil Sawant

over 9 years ago

0 Gautam Iyer over 9 years ago

Guru 192875 points

Hi Sunil,

Refer this link: e2e.ti.com/.../82349

Regards,
Gautam

0 SUNIL SAWANT over 9 years ago in reply to Gautam Iyer

Intellectual 955 points

Thank your Gautam for replying to my post.

Solution mentioned on the link did work.

It seems, i cannot use this solution in Release Mode.

For release mode, can i run the application from Flash Memory ?
Could it be a permanent solution to run the application from flash memory instead of re-organizing blocks in RAM ?

0 Gautam Iyer over 9 years ago in reply to SUNIL SAWANT

Guru 192875 points

Yup, you can very well run the application from Flash memory. Simply refer the flash example code present in controlSuite.

Regards,
Gautam

0 SUNIL SAWANT over 9 years ago in reply to Gautam Iyer

Intellectual 955 points

Thank you Gautam for providing timely support.

0 Gautam Iyer over 9 years ago in reply to SUNIL SAWANT

Guru 192875 points

You're Welcome! Do open a new thread for new queries and don't continue here. Also, close this thread if you fell so.

Goodluck & Regards,
Gautam

C2000™︎ microcontrollers

C2000 microcontrollers forum

Linker Error while building application for TMS320F28335 MCU