Required to read adc result in debug mode on CCS6

Hi Jaydeep,

Are you able to compile and enter the debug mode? I hope you don't receive any errors? Also, if you've been doing this previously and only now you're observing this issue then try switching to a new workspace or clean the current one.

Regards,
Gautam

Jaydeep,

Has this problem been resolved?

Regards
Lori

Of course, thanks for your respond even after 15 days.

Now I have some other problem and I hope little faster reply on this.

I would like to run the two ADC (ADCA & ADCB) simultaneously on 3MSPS in F28075 control card.

I am not able to use software trigger with DMA though I have used PWM but with PWM I have achieved 1MSPS max speed.

I do not wand to generate interrupt at every sample coz it affects other processes.

Please provide appropriate way to do this.

Thanks, Jaydeep

Jaydeep,

Take a look at the this post which has a code example using the DMA with ADC on a similar line of our devices.  For 2 ADCs you have the option of using 1 DMA or separate DMA channels.

If there is something specific you don't see as possible from the post, please let us know and we can look at a more specific code example.

Matt

Thanks for your kind support Matthew,
I have go through that code, That guy has been used ADC ISR for data collection which makes CPU busy, so I would like to use DMA for that.
Again in that code ADC is running on 50KSPS which I have achieved.
My difficulties is to run ADCs on 3MSPS.

Note to anyone reading through this post: the discussion was continued in the following thread e2e.ti.com/.../448954