F2837xS BOR

Sh.Sasaki

Guru 13625 points

Hi everyone,

I want to connect reset IC to F2837xS for BOR(VDDIO).

Should I set this BOR trip point voltage ? VDDIO minimum voltage(3.14V) ?

I want to set as low as possible the monitoring voltage for the noise test.

Best regards,

Mino.M

over 7 years ago

0 Adam Dunhoft over 7 years ago

TI__Expert 7885 points

Hello Mino,

Best practice is to set the trip point to MIN voltage spec of the device (3.14V). Keep in mind that you may have to increase the trip voltage to make up for the accuracy margin of your monitoring IC.

Best Regards,
Adam Dunhoft

0 Sh.Sasaki over 7 years ago in reply to Adam Dunhoft

Guru 13625 points

Hi Adam,

Thank you for your information.

Best regards,

Mino.M

C2000™︎ microcontrollers

C2000 microcontrollers forum

F2837xS BOR