Does STC test always used at cpu power on and test once? because cpu will warm reset when stc test completes.
my application need running no interrupt.
To avoid interruption in your application, it is recommended to run LBIST as a startup test.If you choose to run LBIST during normal operation, it will interrupt the CPU, but you can shorten the time that the CPU is interrupted by dividing the STC into 32 intervals via the STC registers. You will, however, get a reset after each test and have to restore the CPU contents since the test destroys the CPU contents. All CPU contents such as the registers, interrupt settings will be lost.At the beginning of your code, you can distinguish a normal reset and an LBIST reset by checking the SYSESR register.
All content and materials on this site are provided "as is". TI and its respective suppliers and providers of content make no representations about the suitability of these materials for any purpose and disclaim all warranties and conditions with regard to these materials, including but not limited to all implied warranties and conditions of merchantability, fitness for a particular purpose, title and non-infringement of any third party intellectual property right. TI and its respective suppliers and providers of content make no representations about the suitability of these materials for any purpose and disclaim all warranties and conditions with respect to these materials. No license, either express or implied, by estoppel or otherwise, is granted by TI. Use of the information on this site may require a license from a third party, or a license from TI.
TI is a global semiconductor design and manufacturing company. Innovate with 100,000+ analog ICs andembedded processors, along with software, tools and the industry’s largest sales/support staff.