TI E2E Community
MSP430 Ultra-Low Power 16-bit Microcontroller Forum
new firmware of MSP-FET430UIF don't blow fuse with JTAG SBW
I need to blow the fuse of a MSP430G2131 with MSP-FET430UIF connected by SBW.
Firmware of MSP-FET430UIF is the latest 3.02.03.002 and cable is as requested, I can program and read the firmware of MSP430G2131.
When I give the command to blow the fuse (from latest version of IAR or FET-Pro430) no high voltage exits from wire TEST/VPP (checked with oscilloscope).
I changed the firmware of MSP-FET430UIF to old 2.04.09.001 and it blows the fuse.
Has someone the same problem?
or it is a my problem due to using a VMware virtual machine?
Now I have to use 2 MSP-FET430UIF one for program and one for blowing fuse.
This REP430F SBW connection to MSP430G2211 is confusing to me thread mentions a bug with the MSP-FET430UIF firmware about a failure to blow the fuse.
Thank you very much!
All content and materials on this site are provided "as is". TI and its respective suppliers and providers of content make no representations about the suitability of these materials for any purpose and disclaim all warranties and conditions with regard to these materials, including but not limited to all implied warranties and conditions of merchantability, fitness for a particular purpose, title and non-infringement of any third party intellectual property right. TI and its respective suppliers and providers of content make no representations about the suitability of these materials for any purpose and disclaim all warranties and conditions with respect to these materials. No license, either express or implied, by estoppel or otherwise, is granted by TI. Use of the information on this site may require a license from a third party, or a license from TI.
TI is a global semiconductor design and manufacturing company. Innovate with 100,000+ analog ICs andembedded processors, along with software, tools and the industry’s largest sales/support staff.