Problems with ACC/PPT Mode

Marco Bleiker

Hi All!

I have some problems even I`ll change the clock to ACC od PPT Mode.
If I choose ACC with "#" key then press the "v" down key, the wireless symbol comes
for just a half second, then I get a default (?) screen on the clock (pls see attachment)
and the link will not establish...Same on PPT, SynC and rFbSL Mode...

Many thanks for any answer!

over 9 years ago

0 Leo Bosch over 9 years ago

Guru 23000 points

Did you already flashed new software to the Chronos or is it the factory installed one?
Is the battery in very good condition, 3V?
Did you start the PC access point?

0 Marco Bleiker over 9 years ago in reply to Leo Bosch

Prodigy 30 points

Hi, I have still the factory software on the Chronos.
The Battery shows 2.95 V. Is this maybe the problem? Do you know how is the range
for the charge? I`ve tested other 3V. batteries but with that I don`t have anything on the display.
Is there something special to note for a new battery?
Yes, I`ve started access point...On linux and also tested with windows...
Thanks again!

0 Leo Bosch over 9 years ago in reply to Marco Bleiker

Guru 23000 points

Wireless needs a good battery, 2.95V can be too low.
Supply your Chronos with the USB debugging interface (remove the battery), and try again.

0 Marco Bleiker over 9 years ago in reply to Leo Bosch

Prodigy 30 points

Hi Leo

Many thanks for your help! With a new Battery with 3.08V. anything is OK!

Thanks,

Marco

**Attention** This is a public forum

MSP low-power microcontrollers

MSP low-power microcontroller forum

Problems with ACC/PPT Mode