USB driver for MSP432 Launchpad

Stefan Rahtz

Hello,

where can I get the USB drivers for the MSP432 Launchpad?

Im running CCS6.1.0 under WINXP, if I connect the board, the hardware installation routine starts and ask for XDS110 USB driver.

If I search in the folder "ti", I cant find it.

Thanks.

Stefan

over 8 years ago

0 Dennis Eichmann over 8 years ago

Guru 74080 points

If you re-run the installation of CCS and add MSP432 support it will install the drivers.

0 Stefan Rahtz over 8 years ago in reply to Dennis Eichmann

Prodigy 110 points

Hello Dennis,

thank you for reply me.
I did already a reinstallation and also added MSP432 support.
No matter how, but there won't be added an USB driver.

Stefan

0 Dennis Eichmann over 8 years ago in reply to Stefan Rahtz

Guru 74080 points

OK, then maybe it is because Windows XP? I don't know - I remember something with a missing driver, but I'm not 100% sure. You can try these drivers:

Dennis

0 Stefan Rahtz over 8 years ago in reply to Dennis Eichmann

Prodigy 110 points

Hello Dennis,

thanks a lot for the link.
The driver from the link that youu sent me, was inbound successful.

Greetings from Berlin, 26°C.

Stefan

0 John Linsley over 8 years ago in reply to Dennis Eichmann

Intellectual 510 points

Hi Dennis,

I had the same problem on Windows 7 professional. Your link solves the problem. Thank you

John

**Attention** This is a public forum

MSP low-power microcontrollers

MSP low-power microcontroller forum

USB driver for MSP432 Launchpad