This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

MSP430UIF-FET programming

Other Parts Discussed in Thread: MSP-GANG, MSP430G2955

I am trying to program my target MCU-MSP430G2955 using the MSP430UIF-FET through the Elprotonic software.
However, I was facing the JTAG communication error whenever I try to upload my hex file to the controller.
Presently, I am using a two-wire SBW connection with RESET, TEST, Vcc TARGET and GROUND. The MCU is using a local power on-board power supply.
Could you please help in this regard?

Thanks,
Karan

**Attention** This is a public forum