Different behavior in FETPro430-Lite each version

Hello M.Kuramoto,
Can you tell me if you are MSP-FET (black) or FET430UIF (grey)?

I'll loop in our Elprotronic rep.

Also, I can try to recreate and debug this if you tell me what MSP you are using.

Hi Cameron

Thank you for your reply!
I'm using FET430UIF(gray) and MSP430F1232.

Best regards,
M.Kuramoto

Hi Cameron

Can you tell me about the progress on this?

Best regards,
M.Kuramoto

Hi M.Kuramoto,

I relayed your update to Elprotronic and am waiting for an update. However, they did say that they were working on it. 

Hi Cameron

Thank you for your response.
I tried it again, but that is not working on FET-PRO Lite(Version 3.4.1).

Could you tell me the difference between Version 3.3.0 and 3.4.1.

Best regards,
M.Kuramoto

Have you tried updated the firmware on your FET?

Hi Cameron

I tried updated the firmware on MSP-FET430UIF, but that is not working on FET-PRO Lite(Version3.4.1).

The table below shows the combination result of FET Firmware and FET-PROVersion.

〇 : The RST signal level changes to low when the Reset button is pressed

×   : The RST signal level does not change to low when the Reset button is pressed

I think that it is not a problem of FET version.

Best Regards

M.Kuramoto

Hi Cameron

Can you tell me about the progress on this?

Best regards,
M.Kuramoto