CCS/MSP430F5529: Interrupt in MSPBoot

Zakaria ZIDOUH

Part Number: MSP430F5529
Other Parts Discussed in Thread: CC110L

Tool/software: Code Composer Studio

Hello
I work on the over the air firmware update using MSPBoot, and I want that when the target enters the bootloader mode and does not receive any command, after a while, it jumps to the application. I tried with a timer interrupt, when it overflows I jump to the application, but it does not work ...
please how can I solve this problem?
thank you

over 5 years ago

0 Nathan Siegel over 5 years ago

TI__Genius 10980 points

Hi,

What over the air firmware specifically are you referring to? And could you please describe how it is not working?

Regards,
Nathan

0 Nathan Siegel over 5 years ago

TI__Genius 10980 points

Hi,

Has this issue been resolved? If so, please mark the thread as answered. If there is no response soon, this thread will be closed due to inactivity.

Regards,
Nathan

0 Zakaria ZIDOUH over 5 years ago in reply to Nathan Siegel

Prodigy 125 points

Hi Nathan
over the air firmware using bootloader and CC110L, but the problem I have is with the bootloader, how can I make the interrupts work in this mode? normally from what I found on TI documents, it's still possible to use interrupts in bootloader mode. but so my case it did not work.
I can upload the bootloader project so you can take a look if you want
thank you

**Attention** This is a public forum

MSP low-power microcontrollers

MSP low-power microcontroller forum

CCS/MSP430F5529: Interrupt in MSPBoot