CCS: working on a project LaunchPad Development Board

jack rao

Tool/software: Code Composer Studio

Hi, I have a doubt. I'm working on my fyp project ARDUINO UNO. It uses gsm, gps, LaunchPad Development Board and raspberry pi.
I want to connect gsm, gps and raspberry pi to LaunchPad Development Board. How can I connect all these things?

www.allaboutcircuits.com/.../

over 4 years ago

0 JohnS over 4 years ago

TI__Guru**** 159725 points

Jack,

Which LaunchPad are you using? Is it the MSP430G2 one from the article?

Regards,

John

0 jack rao over 4 years ago in reply to JohnS

Prodigy 100 points

first of all thanks your replay

yes i am using MSP430G2 i am making my fyp "car tracker using ti LaunchPad MSP430G2"

0 JohnS over 4 years ago in reply to jack rao

TI__Guru**** 159725 points

Thanks Jack. I will loop in the MSP430 team.

Regards,

John

0 JD Crutchfield over 4 years ago in reply to jack rao

TI__Mastermind 26420 points

Hey Jack,

All example code for the MSP430F2ET launchpad can be found here: http://dev.ti.com/tirex/explore/node?node=AHtAZc-9AUOr1VFjkDPZ8g__IOGqZri__LATEST

What are you wanting to do with the MSP430 in the system?

The MSP430 is a very low power embedded microcontroller. A raspberry pie is probably like 50-100x faster and larger than an MSP430. So in a system like you proposed, the raspberry pi would probably do most the heavy lifting.

Thanks,

0 jack rao over 4 years ago in reply to JD Crutchfield

Prodigy 100 points

thanks a lot and share your knowage and link you provide

my problem is solve and again thanks

i also download library from below link

and MSP430F2ET launchpad can be interface servo motor from this link

**Attention** This is a public forum

MSP low-power microcontrollers

MSP low-power microcontroller forum

CCS: working on a project LaunchPad Development Board