Hi,
I have a fresh stellaris EKS-LM4F232 evaluation kit.i am learning on this kit for my one project. I tried to program by myself but i am unable to dumb program in that kit. whenever i try to load program this error which is shown below comes. Please help as early as possible.
Thanks Regard
M/s Komal Bhosale.
Komal:
I hope you don't mind sharing your space with me as I have a similar problem. I am trying to program a LM3s8962 Evaluation Board with very little success. I am using CCS
v5.1.1.00028
It seems my problems are not limited to just my board, for some reason my carefully thought out problem description failed to fully post.
The following attachment contains a description and screenshots. Komal, I hope TI can help us with both of our difficulties. Best wishes.
3343.stellaris ccsv5 debug unable to connect to target.docx
I am sorry Komal that my difficulties are (temporarily) solved by disconnecting the 10 way ribbon cable to the LM3s2110 CAN Board. I am sorry that I cannot help you with your problems. Your post has been up for some time and I would have thought you'd have a response by now. Best wishes.
Khomal,
It seems you may have changed the system clock frequency to something that won't work. You can use the LMFlash Programmer tool to perform a Debug Port Unlock sequence which should erase the flash and restore communication. Select the Blizzard class when you perform the function. Please let me know if that works.
Regards,
Sue