This thread has been locked.
If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.
Part Number: DRV8301
I am using DRV8301 to drive a 800W BLDC motor.I wanted to know how Vds sense circuitry work? (I mean all the concepts like Vds sense sampling rate, sampling time and how Vds voltage value is determined?)
I asking about this because while using OCP my MOSFETs sometime TURN ON correctly but sometime do not!! (even if Vds is less than Vds trip point). So, I think if i know about Vds sense working then i would be able to select MOSFETs capable to work with OCP enabled.
This information is not given in the datasheet.
How are you using the VDS monitor? Please note section 220.127.116.11 of the datasheet.
The VDS monitor is not intended for precise current regulation.
VDS is monitored when the FETs are enabled. If the VDS is exceeded for ~1.5us, the fault will disable the FETs depending on the OCP_MODE selected.
You can use current limit mode or report only mode as described in section 18.104.22.168 and monitor the nOCTW pin. This will help you determine when the VDS monitors triggered.
Rick DuncanMotor Applications Team
We are glad that we were able to resolve this issue, and will now proceed to close this thread.
If you have further questions related to this thread, you may click "Ask a related question" below. The newly created question will be automatically linked to this question.
In reply to Rick Duncan:
Thanks for the reply.
Lets take a scenario, suppose i give high input at INH_X or INX_L pin then the IC would give high output at GH_X (VDD+GVDD) or GL_X (GVDD). As you said if VDS is exceeded for ~1.5us, the fault will disable the FETs depending on the OCP_MODE selected. So, my MOSFET should turn ON within ~1.5us if not then the fault will be detected because if MOSFET do not completely turn On then Vds would not be equal to ~ 0V, Vds would be greater than Vds trip value.
I am using IRFP260N which have Turn-ON delay time = 17ns , Rise time = 60ns , Turn-OFF delay time = 55ns and Fall time = 48ns. These are in nano seconds!!!. So, my MOSFET should turn ON or IC should not give fault of OCP. But here IC is not turning mosfet ON and giving fault.
Can you please explain why this is happening?
In reply to Shashank more:
All content and materials on this site are provided "as is". TI and its respective suppliers and providers of content make no representations about the suitability of these materials for any purpose and disclaim all warranties and conditions with regard to these materials, including but not limited to all implied warranties and conditions of merchantability, fitness for a particular purpose, title and non-infringement of any third party intellectual property right. TI and its respective suppliers and providers of content make no representations about the suitability of these materials for any purpose and disclaim all warranties and conditions with respect to these materials. No license, either express or implied, by estoppel or otherwise, is granted by TI. Use of the information on this site may require a license from a third party, or a license from TI.
TI is a global semiconductor design and manufacturing company. Innovate with 100,000+ analog ICs andembedded processors, along with software, tools and the industry’s largest sales/support staff.