Part Number: DRV2667EVM-CT
My customer is trying to use the USB2ANY to connect the DRV2667 EVM -CT to the Haptic Control Console GUI. The SW sees the USB2ANY in the usb pulldown, but connect does not seem to do anything.
I searched the web and could not find a user guide on this GUI or on how to use the USB2ANY to connect to the GUI. Any ideas on why it is not connecting properly?
Hello, Yes, there is some special firmware needed to use the USB2ANY. We are waiting for the USB2ANY to release to put up the new firmware and instructions on flashing the device. I will send you an email with the instructions.
Regards,Kelly GriffinApplication Engineer
All content and materials on this site are provided "as is". TI and its respective suppliers and providers of content make no representations about the suitability of these materials for any purpose and disclaim all warranties and conditions with regard to these materials, including but not limited to all implied warranties and conditions of merchantability, fitness for a particular purpose, title and non-infringement of any third party intellectual property right. TI and its respective suppliers and providers of content make no representations about the suitability of these materials for any purpose and disclaim all warranties and conditions with respect to these materials. No license, either express or implied, by estoppel or otherwise, is granted by TI. Use of the information on this site may require a license from a third party, or a license from TI.
TI is a global semiconductor design and manufacturing company. Innovate with 100,000+ analog ICs andembedded processors, along with software, tools and the industry’s largest sales/support staff.