TSC2013EVM ISSUE

MAHESH VASTRAD

Prodigy 100 points

Other Parts Discussed in Thread: TSC2013EVM

Hi All,

I have bought TSC2013EVM for working on RESISTIVE TOUCH interface.

the board is not powering up once I connect the USB cable & default switch selection on the DIP-SWITCH.

kindly let me know if anyone have faced similar issue & worked on this board.

NEED INSTRUCTIONS & STEPS TO FOLLOW TO WORK ON THIS EVM & ALSO HOW TO RE-FLASH IT.

Regards

Mahesh Vastrad

over 8 years ago

0 Andy Liu (BMS) over 8 years ago

TI__Guru 52115 points

Hi Mahesh,

Did you see the power-indicator LED (LED502) was on when this board was connected to your PC? Did you try using a multi-meter to make sure whether this board was actually powered on or not? The schematic is available in the TSC2013EVM User's Guide.

Andy

0 MAHESH VASTRAD over 8 years ago in reply to Andy Liu (BMS)

Prodigy 100 points

Hi Andy,

Thanks for suggesting me to look into the Hardware & debug it,

the LED502 was not glowing ON, so I went through schematic & found that F500 was not showing continuity, hence further circuit was not getting voltage.
I replaced F500 & now the board is working perfectly.

Mahesh Vastrad

0 Chris Pickard over 8 years ago in reply to MAHESH VASTRAD

Prodigy 10 points

Hi All
My board came with an open F500 too, Mahesh I'm glad you found it first and Andy knew what it was, no time wasted.
Chris.

Data converters

Data converters forum

TSC2013EVM ISSUE