This thread has been locked.
If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.
Part Number: CSD95375Q4M
I'm very impressed with the performance and integration level of the Synchronous Power Stage. I would like to use the CSD95375Q4M in the following configuration, which is a little different than the typical application in the datasheet.
The switching topology is a buck+boost conveter, with 2x CSD95375Q4M ICs in a bridge-like configuration with the inductor in the "middle" of the bridge. So IC1 Vin is connected to Vbat (0.85-3.9V), Pgnd is connected to Vbat-neg(0V), and Vsw is connected to L1(terminal 1). IC2 Vin is connected to Vout (0-3.7V), Pgnd Vbat-neg(0V), Vsw L1 (terminal 2).
Vdd is supplied externally at 5.0V nominal.
To achieve this configuration I need 100% duty cycle on the non-switching side of the bridge (IC2 High in buck mode, IC1 High in boost mode). The control of the PWM and SKIP# pins is achieved through digital control.
Here are my questions:
1. The datasheet specifies a maximum on-time duty cycle of 85% ("6.2 Recommended Operating Conditions"). I assume that this is required by the bootstrap capacitor design. I'd like to provide my own high-side gate drive supply voltage ("Vgd") via a schottky diode into BOOT pin (thus replacing the BOOT capacitor). Assuming this is provided, can I drive the PWM pin to provide 100% high-side on duty cycle?
2. Assuming 1) is possible, what should Vgd be to not exceed the Vgs rating of the internal MOSFET? Nominal operating voltage range on the Vsw pins will be in the range of 0-3.9V. So would a Vgd of 7V for example be safe?
Product Marketing Engineer
We are glad that we were able to resolve this issue, and will now proceed to close this thread.
If you have further questions related to this thread, you may click "Ask a related question" below. The newly created question will be automatically linked to this question.
In reply to Brett Barr1:
All content and materials on this site are provided "as is". TI and its respective suppliers and providers of content make no representations about the suitability of these materials for any purpose and disclaim all warranties and conditions with regard to these materials, including but not limited to all implied warranties and conditions of merchantability, fitness for a particular purpose, title and non-infringement of any third party intellectual property right. No license, either express or implied, by estoppel or otherwise, is granted by TI. Use of the information on this site may require a license from a third party, or a license from TI.
TI is a global semiconductor design and manufacturing company. Innovate with 100,000+ analog ICs andembedded processors, along with software, tools and the industry’s largest sales/support staff.