This thread has been locked.
If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.
Part Number: LM25119
My customer reported, their LM25119 design can properly enter hiccup mode in overload protection, while cannot in short circuit test. I think it is the result of current sensing mechanism of this device, correct? How can i solve this issue? (Though short circuit fault does not result damage to ckt, while the power consumption is too high if it does not enter hiccup mode.)
We are glad that we were able to resolve this issue, and will now proceed to close this thread.
If you have further questions related to this thread, you may click "Ask a related question" below. The newly created question will be automatically linked to this question.
In reply to Qian Chen:
Thank you for reply.
I think it related to the input voltage and inductance. Customer's design is 24V input, 5VOUT, 3uH inductance. You can try this configuration. Customer do short ckt test with wire short. Have confirmed the VIN is stable during short circuit test.
I think maybe this is the inherent feature of the device.
The condition for device to enter hiccup mode is "...detects 256 consecutive cycles of current limiting". Once the output is shorted to GND, there will be excess recirculating current in inductor, this will result the sample-and-hold DC level exceeds the internal current limiting threshold and succeeding cycles are skipped, failed to meet " 256 consecutive cycles of current limiting". Such the device cannot enter hiccup mode, instead it entering pulse skipping mode. This is exactly what customer observed. Please confirm if this is the root cause? And if so, how should we solve this problem?
Also attached is customer's schematic.
In reply to John11513:
The theory that the part can not enter hiccup due to pulse skip is possible.
Can you provide the schematic with component value, so I can get more design information like Fsw, current sense circuit value and etc?
Can you try higher output inductance and check if it helps part enter the hiccup?
Here is the new one with component value:
Can you increase R237, R238, R256, R257 value to 20 ohm or larger and check if it helps? Also, please check if C161 and C179 are close to CS/CSG pins in layout.
What's the load current per phase? Please try larger output inductance. If new inductor DCR increases, the sensing resistor value needs to be adjusted accordingly.
All content and materials on this site are provided "as is". TI and its respective suppliers and providers of content make no representations about the suitability of these materials for any purpose and disclaim all warranties and conditions with regard to these materials, including but not limited to all implied warranties and conditions of merchantability, fitness for a particular purpose, title and non-infringement of any third party intellectual property right. TI and its respective suppliers and providers of content make no representations about the suitability of these materials for any purpose and disclaim all warranties and conditions with respect to these materials. No license, either express or implied, by estoppel or otherwise, is granted by TI. Use of the information on this site may require a license from a third party, or a license from TI.
TI is a global semiconductor design and manufacturing company. Innovate with 100,000+ analog ICs andembedded processors, along with software, tools and the industry’s largest sales/support staff.