If you are new to LM3697, what should you do to light up the LED load? where should you find the reference code? And what do these registers mean? How to configure them?
This thread has been locked.
If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.
If you are new to LM3697, what should you do to light up the LED load? where should you find the reference code? And what do these registers mean? How to configure them?
If you are new to backlight driver and LM3697, here is a summary of how to use it and some frequently asked questions. The content is:
•Schematic of LM3697
•Linux reference code
•Minimum steps to light up LM3697
•If only 2 channels are used, how to config
•If PWM dimming is used, how to config
•How to setup Dimming performance register
•How to setup dimming configuration register
•How to setup maximum current
•How to setup Boost control
Details, please refer below attachment.