Its regarding document slusaf2a.pdf. There seems to be some confusion, at least to me, on page 26.
1. Under "INPUT ACFET AND RBFET SELECTION", line 2, it should be referring to Figure 23 instead of 22.
2. In Figure 23, the questionable component is resistor Rsns. Shouldn't that be Rac? Rsns should be next to the inductor, isn't?
Please help me clarify this. Thanks.
SLUSAF2A.pdf is bq24171's datasheet. You are right. The figure number should be 23. Also, Rsns isn't used on anywhere else. Call it Rac that makes sense. I will contact system engineer and update the datasheet.
2. No, it did. If you refer to page 27 Fig 25, it is named again Rsns with specific instructions to connect from SRP & to SRN but Rsns on Fig 23 is connected after RBFET & PVcc. I know the part is sense res but kind of confusing if used in such manner.
All content and materials on this site are provided "as is". TI and its respective suppliers and providers of content make no representations about the suitability of these materials for any purpose and disclaim all warranties and conditions with regard to these materials, including but not limited to all implied warranties and conditions of merchantability, fitness for a particular purpose, title and non-infringement of any third party intellectual property right. TI and its respective suppliers and providers of content make no representations about the suitability of these materials for any purpose and disclaim all warranties and conditions with respect to these materials. No license, either express or implied, by estoppel or otherwise, is granted by TI. Use of the information on this site may require a license from a third party, or a license from TI.
TI is a global semiconductor design and manufacturing company. Innovate with 100,000+ analog ICs andembedded processors, along with software, tools and the industry’s largest sales/support staff.