TI E2E Community
Battery Management - Chargers Forum
SolarCharger of BQ24650
The HIDRV pin and LODRV pin can't provide PWM?
Thanks for your explanation.
Typically for a solar charger with a MMP of 17.2V on the solar panel, the open circuit voltage would be 21.5V and the charger would load the input until the solar panel's output voltage drops to ~17.2V.
Are you just putting 17.2V on the input? If so, as soon as the charger starts to load the circuit it hits the MPP threshold and reduces the power transfer.
If you are testing with a lab supply, set the supply to 2.15V and apply a series resistor (R= 21.5V-17.2V / Immp); where Immp is the expected current delivered at 17.2V (maximum power point threshold).
Fix the problem?
I have the same quetion. How?
All content and materials on this site are provided "as is". TI and its respective suppliers and providers of content make no representations about the suitability of these materials for any purpose and disclaim all warranties and conditions with regard to these materials, including but not limited to all implied warranties and conditions of merchantability, fitness for a particular purpose, title and non-infringement of any third party intellectual property right. TI and its respective suppliers and providers of content make no representations about the suitability of these materials for any purpose and disclaim all warranties and conditions with respect to these materials. No license, either express or implied, by estoppel or otherwise, is granted by TI. Use of the information on this site may require a license from a third party, or a license from TI.
TI is a global semiconductor design and manufacturing company. Innovate with 100,000+ analog ICs andembedded processors, along with software, tools and the industry’s largest sales/support staff.