BQ25895M - Question

Eddy Lee

Intellectual 840 points

Other Parts Discussed in Thread: BQ25895M

Hello,

I have a question is Diode(20V,1A) function and operation.

Please send me your comment.

Best regards,

Eddy

over 7 years ago

0 Jeff F over 7 years ago

TI__Guru*** 143970 points

Are you referring to the additional Schottky diode from SW to PMID on the schematic? If so, then that diode is used during OTG mode to improve efficiency by providing a lower voltage drop than the internal rectifying FET's body diode.

0 Eddy Lee over 7 years ago in reply to Jeff F

Intellectual 840 points

Hi Jeff
Thank you for your kind support.

And One more question.

QTG available 3.1A and if I have need schottky diode to raise the rating?

Eddy

0 Eddy Lee over 7 years ago in reply to Eddy Lee

Intellectual 840 points

Hi Jeff

One of customer design in BQ25895M and have some question of several REGxx function.

Customer product inside power bank and first time using BQ25895M part.

Status is 1st working and then 2nd PP start 3week of June. about 100 set.

Please refer to the attached customer question and please support of it.

Best regards,

Eddy(eddy.lee@avnet.com)

BQ25895M_question_E2E.pptx

0 Jeff F over 7 years ago in reply to Eddy Lee

TI__Guru*** 143970 points

Higher efficiency from external diode during boost mode does typically allow for slightly higher output current but we cannot warranty such operation due to external component.

Power management

Power management forum

BQ25895M - Question