Part Number: BQ35100
I plan to use the BQ35100 in a system, which is powered by a 3V CR2 battery (Lithium Manganese Dioxide (LiMnO2) chemistry).The system is designed to run with a voltage down to 2.5V, while the battery is discharging.
The datasheet of the BQ35100 states two supply voltage ranges. One from 2.7V to 4.5V with "No operating restrictions" and 2.45V to 2.7V with "No FLASH writes".
As I understand the reference manual correctly, flash writes are necessary for calibration, Accumulator mode and End-Of-Service (EOS) mode.Calibration will be done one time for the system with a full battery at 3V.Because of the used battery, the BQ35100 will run in the STATE-OF-HEALTH (SOH) mode.
So my questions are:
with kind regards
In reply to Bryan Kahler:
Hi Bryan, hi Onyx,
thank you for your replies.
Can one of you give me a distinct 'yes' or 'no' for the voltage range 2.5V to 3V in SOH mode?
with best regards
In reply to SST:
All content and materials on this site are provided "as is". TI and its respective suppliers and providers of content make no representations about the suitability of these materials for any purpose and disclaim all warranties and conditions with regard to these materials, including but not limited to all implied warranties and conditions of merchantability, fitness for a particular purpose, title and non-infringement of any third party intellectual property right. TI and its respective suppliers and providers of content make no representations about the suitability of these materials for any purpose and disclaim all warranties and conditions with respect to these materials. No license, either express or implied, by estoppel or otherwise, is granted by TI. Use of the information on this site may require a license from a third party, or a license from TI.
TI is a global semiconductor design and manufacturing company. Innovate with 100,000+ analog ICs andembedded processors, along with software, tools and the industry’s largest sales/support staff.