I'm unknowingly dumped/downloaded program with checksum into flash memory of ucd30xx ic.how i can reprogram the same device using Fusion Digital Power Designer.
How I can detect ROM of Ucd30xx for reprogram a device.please help me to comeout from program flash to ROM.
Thanks & Regards
We can easily detect ROM of Ucd30xx using TI's USB-TO-GPIO programmer. You can find out the TI's website for the details of USB-TO-GPIO programmer which uses a 10 pin PMBus programming pin for faster programming. The instructions and details can be found in the technical documents related to the programmer.
Yes ur right.but programmed with checksum means the device is in flash mode(FORever).it will not comeback again in ROM mode.so my queation is how i can comeback from FLASH mode to ROM mode(using PMBus command).If you detect a ROM of ucd30xx you can program again a device with no issue.
I hope You got my problem.
Thanks & Regards
Last step missing
4. Under the Tools section click on Device ID to discover the controller, this should activate the line Command Program to jump to ROM (SendByte 0x09), click this link and the device should be returned to ROM mode.
I tried whatever you suggested but I'm unable to detect a ROM of UCD3020.Your procedure is valid only when program written without valid CHECKSUM. But programmed with Valid CHECKSUM.
when I clicked on DEVICE ID it is giving scanning address 1-11 and 13-127 for program mode address.
No device found.
and Command Program to jump to ROM (SendByte 0xD9)is not activated.
Is there any other way to do this.
My experience is with the UCD92xx DC/DC POL controllers which are similar in archetechure to the UCD3xxx parts but come with a pre-loaded firmware.
Only devices which have firmware written with a valid checksum will be in Program mode and only devices in Program mode will respond to the Device ID request. Devices without a valid checksum will remain in ROM mode, they would respond to the Scan Device in ROM Mode command and would not require the procedure I provided nor would they respond to it.
If you have written firmware with a valid checksum then the device will be in Program Mode after initialization. If it is in Program mode then the only way to return to ROM mode is to send the command 0xD9 to the controller. If your firmware is not responding to PMBus communication, no response to DeviceID command, then it may not be possible to restore ROM mode.
The Command Program to jump to ROM mode actually erases the firmware checksum which re-enables ROM mode.
Thank you very much for your clear explanation.your saying what I'm written firmware which will not restore ROM mode.
You are right it's problem with my firmware(firmware is not responding to PMBus communication) I corrected now it's working fine.
Thank you very much.
All content and materials on this site are provided "as is". TI and its respective suppliers and providers of content make no representations about the suitability of these materials for any purpose and disclaim all warranties and conditions with regard to these materials, including but not limited to all implied warranties and conditions of merchantability, fitness for a particular purpose, title and non-infringement of any third party intellectual property right. TI and its respective suppliers and providers of content make no representations about the suitability of these materials for any purpose and disclaim all warranties and conditions with respect to these materials. No license, either express or implied, by estoppel or otherwise, is granted by TI. Use of the information on this site may require a license from a third party, or a license from TI.
TI is a global semiconductor design and manufacturing company. Innovate with 100,000+ analog ICs andembedded processors, along with software, tools and the industry’s largest sales/support staff.