TI E2E Community
Digital Power Forum
UCD9240 datasheet error (note 6)
I believe that note 6 on page 4 of the UCD9240 datasheet is an error. It says "The PMBus command: EADC_SAMPLE_TRIGGER defines the start of the 32ns ADC sample window. So the minimum EAD_SAMPLE_TRIGGER time is 208 + 32 = 240 ns." My understanding is that the 32 ns sample window immediately precedes (in time) the trigger point, and that the actual minimum EAD_SAMPLE_TRIGGER time is 224 ns.
Your observation about the sample window is correct.
Submitted for correction: Update 80ns reference for EADC sample window to 32ns.
One of my other posts references the 80nsec error in Power Designer. This post talks about the error in the UCD9240 datasheet. Did you mean to say that the datasheet error was submitted for correction?
All content and materials on this site are provided "as is". TI and its respective suppliers and providers of content make no representations about the suitability of these materials for any purpose and disclaim all warranties and conditions with regard to these materials, including but not limited to all implied warranties and conditions of merchantability, fitness for a particular purpose, title and non-infringement of any third party intellectual property right. TI and its respective suppliers and providers of content make no representations about the suitability of these materials for any purpose and disclaim all warranties and conditions with respect to these materials. No license, either express or implied, by estoppel or otherwise, is granted by TI. Use of the information on this site may require a license from a third party, or a license from TI.
TI is a global semiconductor design and manufacturing company. Innovate with 100,000+ analog ICs andembedded processors, along with software, tools and the industry’s largest sales/support staff.