TI E2E Community
Digital Power Forum
UCD9222 & UCD7242 problem
I'm now debugging our C6678 board. We use UCD9222 & UCD7242 for DSP core power supply. Our design is almost the same with the EVMC6678L, so we use the same configuration file as the EVM.
Now we are able to download the configuration to UCD9222 through the USB-TO-GPIO tool. But it does not work. The PWM outputs of UCD9222 stay low. (I did the same download process on the EVM, and that's OK. )
So I wander did I miss something? What key points should I consider when debugging the UCD9222? Attached our schematic and .xml file .(We only soldered the power section of our board for debug)
Any help / suggestion would be greatly appreciated!
Our DPWM output is also low (3-state). Configuration data to UCD (9244) was trasmitted over PMBus by EVMc6678 board and validated by reading it back. DPWM output is quite.
All content and materials on this site are provided "as is". TI and its respective suppliers and providers of content make no representations about the suitability of these materials for any purpose and disclaim all warranties and conditions with regard to these materials, including but not limited to all implied warranties and conditions of merchantability, fitness for a particular purpose, title and non-infringement of any third party intellectual property right. TI and its respective suppliers and providers of content make no representations about the suitability of these materials for any purpose and disclaim all warranties and conditions with respect to these materials. No license, either express or implied, by estoppel or otherwise, is granted by TI. Use of the information on this site may require a license from a third party, or a license from TI.
TI is a global semiconductor design and manufacturing company. Innovate with 100,000+ analog ICs andembedded processors, along with software, tools and the industry’s largest sales/support staff.