Pardon my ignorance as I am still digging through the documentation. I have to replace a UCD9248 on a proto board. As I don't have the original power design project, is there a way to copy the configuration from the UCD9248-to-be-replaced and download it to the the new chip that has the factory configuration?
Just here to answer my own question. Connecting to the board with Fusion Digital Power Designer, exporting the configuration to a project file, replacing the chip and downloading the project to the new chip did the trick.
All content and materials on this site are provided "as is". TI and its respective suppliers and providers of content make no representations about the suitability of these materials for any purpose and disclaim all warranties and conditions with regard to these materials, including but not limited to all implied warranties and conditions of merchantability, fitness for a particular purpose, title and non-infringement of any third party intellectual property right. TI and its respective suppliers and providers of content make no representations about the suitability of these materials for any purpose and disclaim all warranties and conditions with respect to these materials. No license, either express or implied, by estoppel or otherwise, is granted by TI. Use of the information on this site may require a license from a third party, or a license from TI.
TI is a global semiconductor design and manufacturing company. Innovate with 100,000+ analog ICs andembedded processors, along with software, tools and the industry’s largest sales/support staff.