• State
  • Locked Locked
  • Replies 2 replies
  • Subscribers 62 subscribers
  • Views 546 views
  • Users 0 members are here
Support feedback
Options
Options
Similar topics

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

Changing Address for UCD9248 using Fusion Digital Power Designer

Shehzad
Intellectual 320 points
Other Parts Discussed in Thread: UCD9248

Hi,

I am creating project in  Fusion Digital Power Designer for UCD9248, when i create a new project then software by default set its name to  UCD9248 @ Address 126d Project. As i need to create 3 different projects then how can i change its name and address ??? 

  • 0
    TI__Genius 9845 points
    The GUI does not set PMBus address for the device. Instead, the GUI discovers devices at different address.

    The UCD9248 address is configured by adding resistors to the address pins. Please refer to the datasheet. If any address pin is left floating, the device uses the default address 126d.

    Thanks,
    Zhiyuan
  • 0 in reply to Zhiyuan Hu
    Intellectual 320 points

    Yes i have already set that address to 52, 53, 54 and 55 using resistor on address pins of UCD9248. But i am unable to change the project name. How can i change the project name?

    waiting for your reply!!